CipherLab 1266 Betriebsanweisung PDF herunterladen (Seite 26)

ScanManager User Guide

1.2 POWER MANAGEMENT (1166/1266)

The scanner will stay active at power-on for 1 minute, which will be followed by different

power-saving mechanism.

 Power-Saving: When the scanner fails to connect within 1 minute, it will enter

power-saving mode automatically.

 RF Auto-Shutdown (1~255 min.; 0= Disable): By default, when the scanner is idle for

10 minutes, it will automatically stop RF connectivity. If this feature is not desired, set

it to 0.

Before establishing a WPAN connection successfully…

1. The scanner will stay active for a preset period of time (1 minute) for the following scenarios.

Its LED is flashing blue (On/Off ratio 1:1).

(a) waiting for a connection request from the host (BT SPP Slave Mode)

(b) trying to connect to the host (BT HID)

2. If it fails to connect within 1 minute, the scanner will become inactive to save power, and its

LED will turn off.

Press the trigger to wake up the scanner when it becomes inactive, and the scanner will stay

active again.

Note: For scenarios (a) and (b) in step 1, on your computer you may need to search for

the scanner again.

After establishing a WPAN connection successfully…

1. Once a WPAN connection is established successfully, the scanner will stay active for data

transmission. Its LED is flashing blue (On/Off ratio 1:6).

2. With the use of 3666, the scanner will automatically stop RF connectivity when it is idle for the

specified time interval for RF Auto-Shutdown. You will hear three short beeps, tone

descending from high to low, and its LED will turn off.

Press the trigger to wake up the scanner when it becomes inactive, and the scanner will stay

active again.

 For BT HID or SPP, there is no implementation of RF Auto-Shutdown.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 91 92

Keine Kommentare

CipherLab 1266 Betriebsanweisung Seite 26