CipherLab 1562 Betriebsanweisung PDF herunterladen (Seite 50)

ScanMaster User Guide

3.2 CODE 25 — INDUSTRIAL 25

By default, the scanner is set to read Industrial 25 barcodes.

 Advanced settings are provided as shown below.

Start/Stop Selection

Select a desired start/stop pattern. For example, flight tickets actually use an Industrial 25

barcode but with Interleaved 25 start/stop pattern. In order to read this barcode, the start/stop

pattern selection of Industrial 25 should set to Interleaved 25.

Verify Checksum

Select the check box so that the scanner

will perform checksum verification when decoding

Industrial 25 barcodes. If the checksum is incorrect, the barcode will not be accepted.

Transmit Checksum

The checksum character will be included in the data being transmitted.

Cancel the check box if the checksum character is not desired.

Length Qualification

Because of the weak structure of the 2 of 5 barcodes, it is possible to make a "short scan" error.

To prevent the "short scan" error, configure the "Length Qualification" settings to ensure that the

correct barcode is read by qualifying the allowable code length. The barcode can be qualified by

"Fixed Length" or "Max/Min Length".

 For "Fixed Length", up to 2 fixed lengths can be specified.

 For "Max/Min Length", the maximum length and the minimum length must be specified. The

scanner will only accept those barcodes with lengths that fall between max/min lengths

specified.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 81 82

Keine Kommentare

CipherLab 1562 Betriebsanweisung Seite 50