CipherLab 1562 Betriebsanweisung PDF herunterladen (Seite 31)

Chapter 1

Changing Scanner Settings

Multi-Barcode Mode

The scanner will be scanning as long as the trigger is held down, capable of decoding one single

barcode, as well as a multiple unique barcodes one at a time. While decoding a bunch of unique

barcodes, if a barcode is decoded twice, its subsequent decoding will be ignored and the scanner

is expecting another unique barcode.

For the 2D scanners to decode multiple unique barcodes, the maximum output data length of all

the barcodes is 10 KB (1504/1564/1664) and 2042 bytes (1704) after configuration. When the

output length exceeds the maximum length allowed, Multi-Barcode Mode will not take effect.

 The scanning won't stop until you release the trigger.

Note: (1) A barcode is considered unique when its Code Type or data is different from

others. (2) Multi-Barcode Mode has nothing to do with the Multi-Barcode Editor.

Presentation Mode (1504, 1564 and 1704 only)

The scanner will be expecting barcodes. Whenever a barcode is brought within range, the scanner

will be able to decode it. It is suggested to seat it in the Auto-Sense Stand for hands-free

operation.

1.1.1 SCANNING TIMEOUT

Specify the scanning time interval (1~254 sec.; 0= disable) when the scan mode is set to

any of the following scan mode –

 Laser mode

 Auto Off mode

 Auto Power Off mode

 Aiming mode

1.1.2 CONTINUOUS MODE DECODE DELAY

Set the time interval between each decoding when in Continuous Mode.

1.1.3 AIMING TIMEOUT

You can limit the aiming time interval (1~15 sec.) when in Aiming Mode. By default, the

scanner time-out is set to 1 second.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 159 160

Keine Kommentare

CipherLab 1562 Betriebsanweisung Seite 31