CipherLab 1562 Betriebsanweisung PDF herunterladen (Seite 35)

Chapter 1

Changing Scanner Settings

1.2.3 AUTO POWER OFF

The setup of an “Auto Power Off” time is available to any scan mode other than

Continuous Mode, Test Mode and Alternate Mode.

Select “Auto Power Off” and assign a time (1~254 min.; 0= disable) for the scanner that

is set to none of the above mentioned modes to automatically shut down after power-on.

The default value is set to 10 minutes, which means the scanner automatically shuts

down 10 minutes after power-on by default.

Note: For 1560 and 1564, when they are set to Auto-Sense mode and seated in the

Auto-Sense Stand, “Auto Power Off” won’t work.

1.2.4 AUTO POWER OFF IGNORING SCAN MODE (1560/1564)

“Auto Power Off Ignoring Scan Mode” is provided for Continuous Mode, Test Mode and

Alternate Mode only.

Select “Auto Power Off Ignoring Scan Mode” and assign a time (1~254 min.; 0= disable)

to force a scanner set to any of the above mentioned modes to automatically shut down

at the assigned time after power-on.

The default value is set to 10 minutes, which means the scanner automatically shuts

down 10 minutes after power-on by default.

1.2.5 LOW BATTERY ALARM

By default, the low battery alarm is enabled. When the battery level drops below a

specified level, the scanner will respond with a warning beep.

 For 1660, “Enable (Alkaline)” is selected for low battery level by default. If you are

using Ni-MH batteries, select “Enable (Ni-MH)”.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 159 160

Keine Kommentare

CipherLab 1562 Betriebsanweisung Seite 35