CipherLab 1562 Betriebsanweisung PDF herunterladen (Seite 72)

ScanMaster User Guide

2.5.1 AUTHENTICATION

When any changes are made to the authentication and PIN code on the scanner side, you

have to remove the scanner from the paired device list (called unpairing) and go through

the whole process to re-establish the connection. The scanner allows up to 16 characters

for a PIN code and provides two options for authentication:

Enable Authentication with Preset PIN

Select the check box of “Authentication”, and enter exactly the same string in the “PIN Code” field

as the preset PIN for your computer or PDA to connect to the scanner. If the PIN or passkey is

incorrect, any connection attempt will be turned down by the scanner.

Enable Authentication with Random PIN or No Authentication

By default, it is set to “No PIN or use random PIN”, which depends on the setting of the target

device. (No PIN = No authentication.)

Note: For Bluetooth HID, some device driver may not support pre-defined PIN code for

authentication. In this case, make sure you cancel the check box of

“Authentication” to have the scanner set to “No PIN or use random PIN” before

pairing. While pairing, the host PIN code will display on the computer screen. Have

the scanner read the setup barcode “Enter PIN Code in Decimal” or “Enter PIN

Code in Hexadecimal” to input the matching PIN code.

Use random PIN

o PIN require

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 159 160

Keine Kommentare

CipherLab 1562 Betriebsanweisung Seite 72